When drilling down to a list from a Multilevel Pivot Report, filters are not applied. The list shows all records instead of showing only the filtered records.

Steps to Reproduce


  1. Navigate to Reports > Create New.
  2. Create a Multilevel Pivot Report with Asset table or any other table.
  3. Click on a number in any column.
    Note that a list of records is displayed, but the filtered record count in the list does not match the number of records in the cell that was clicked.


This issue is under review. If you are able to upgrade, check the Fixed In field below to determine the versions that have a permanent fix. You can also subscribe to this known error article (click Subscribe button at the top of the article) to receive notifications when more information is available about this issue.

Related Problem: PRB691490

Seen In

Geneva Patch 7
Geneva Patch 7 Hot Fix 2
Helsinki Patch 2

Fixed In

Geneva Patch 8

Associated Community Threads

There is no data to report.

Article Information

Last Updated:2017-05-12 09:00:36